3724 fermentation: when is it a problem?

Sat May 07, 2011 7:56 am

I've brewed with 3711 a few times, but I brewed with 3724 for the first time last weekend. Over 3 days I drove the fermentation up from 68 to 80. It fermented well until day 3 when it stopped and gravity halted at about 1.040. Four days later I checked, and it's still at 1.040.

How long is a typical fermentation with this yeast?

How long does the gravity sit stalled before I should consider it a problem and pitch a second yeast?

Thanks!
EGADS! 3 MONTHS WITHOUT BREWING? MOVING YOU SUCK.... NEVER AGAIN

In Kegerator - Hopfen Weiss, Best Bitter
In Primary - Baby Baine Barleywine
Next up: Petite Saison
User avatar
thatguy314
 
Posts: 850
Joined: Wed Mar 26, 2008 12:14 pm
Location: Bronx, NY

Re: 3724 fermentation: when is it a problem?

Sat May 07, 2011 9:17 am

What was your grain bill like? Lots of simple sugars or no? OG? The last time I brewed with this one it took me 5 wks to get a 1.055 saison down to 1.008 and that was keeping it at 68 for 48 hrs and then ramping it up between 80-95 deg for the remainder of the fermentation, with many swirlings of the carboy to rouse the yeast.

I then used the yeast to repitch into a stronger 1.068 dark saison and within a 3 wk time period the beer finished at 1.013 upon which I added some brett B. to furhter attenuate things.

So, I would give your carboy a good swirl or two to resuspend the yeast and keeping it around 80 deg (don't let it drop temps) let it go for at least another 10-12 days before deciding if you need to add another yeast. I will bet that your yeast will continue to slowly chomp on that 1.040 gravity over time if you are patient. After 2 wks if it is still at 1.040 then you might consider adding a rolling starter.
"A bad man is a good man's job, while a good man is a bad man's teacher."
brewinhard
Global Moderator
 
Posts: 4060
Joined: Sat Oct 25, 2008 8:41 am
Location: Fredonia, NY

Re: 3724 fermentation: when is it a problem?

Sat May 07, 2011 10:58 pm

that sounds about normal for this yeast, it will go like clappers for a while and then just stop dead. dont stress though because it will take of again and given plenty of time it will attenuate down to a very dry beer. i have had it go from 1060 to 1020 in three days and then take six weeks to finish at 1008. it also likes to be warm so 85 or higher is definatly not out of the question.
beerhog
 
Posts: 85
Joined: Sat Oct 24, 2009 2:55 pm
Location: melbourne, aus

Re: 3724 fermentation: when is it a problem?

Sun May 08, 2011 7:27 pm

five weeks in the eighties...normal.
On Deck: Bier de Garde, Northern German Pils
In Fermenters: Homegrown Pale Ale
in keg: Octoberweizen, Dusseldorf Alt
edisonst
 
Posts: 270
Joined: Sat Nov 15, 2008 7:47 am
Location: Wash Dc Area

Re: 3724 fermentation: when is it a problem?

Sun May 22, 2011 5:39 am

I have my saison in the fermentor right now. I used the 3724 and at 2 weeks it had only come down to 1.030 from 1.060. (48 hours at 68 then up to 80 increasing by 1 deg every 12 hours) I then pitched an active starter of the 3711.(at 80 deg) fermentation kicked up a bit for 24 hours then went back down to what it had been doing before I pitched the 3711. (going by airlock activity and appearence) It's been almost a week since I pitched the 3711 and airlock activity is definately slowing. I plan on checking the gravity again today or tomorrow. I had planned on adding the 3711 from the get go to see If I could dry this beer out faster and to see if It adds any benificial flavor dementions. In retrospect I should have split a portion of the batch to do a side by side. Anyway I'll post my results fyi later. keep us posted with your results.

Prost,
PB
Main Entry: zymurgist
Part of Speech: n
Definition: a scientist who studies the chemical process of fermentation in brewing and distilling; also, by extension, a brewer
User avatar
Pharmbrewer
 
Posts: 169
Joined: Sat Oct 24, 2009 2:00 pm
Location: Missoula MT

Re: 3724 fermentation: when is it a problem?

Wed May 25, 2011 9:23 am

The 3711 brought it down to 1.009 in 5 days and thats with no sugars added. I mashed at 152 for 15 min and then added cold water to get down to 149 for total time of 90 min. Taste is phenominal! This is one of the best beers I've ever made. I don't even think I'd bother doing a side by side. This will be my standard method for a Saison.Total fermentation time 19 days Kettle to keg.
Main Entry: zymurgist
Part of Speech: n
Definition: a scientist who studies the chemical process of fermentation in brewing and distilling; also, by extension, a brewer
User avatar
Pharmbrewer
 
Posts: 169
Joined: Sat Oct 24, 2009 2:00 pm
Location: Missoula MT

Re: 3724 fermentation: when is it a problem?

Tue May 31, 2011 12:19 pm

At 4 weeks yesterday it was down 1.028.... still moving slowly, but not well. Since I have it at a high temp I think I'm going to rack to 2' this week. If it doesn't keep dropping after that I'll have to take some measures. Maybe pitch an active 3724 on top of it, maybe some 3711... maybe some brett (my first brett beer). Still deciding.
EGADS! 3 MONTHS WITHOUT BREWING? MOVING YOU SUCK.... NEVER AGAIN

In Kegerator - Hopfen Weiss, Best Bitter
In Primary - Baby Baine Barleywine
Next up: Petite Saison
User avatar
thatguy314
 
Posts: 850
Joined: Wed Mar 26, 2008 12:14 pm
Location: Bronx, NY

Re: 3724 fermentation: when is it a problem?

Tue Jun 21, 2011 5:27 pm

Brett will take longer to get the beer down to bottling gravity than letting 3724 finish out would.
DragonOrta
 
Posts: 5
Joined: Fri Jan 28, 2011 9:06 pm

Next

Return to Fermentation

Who is online

Users browsing this forum: No registered users

A BIT ABOUT US

The Brewing Network is a multimedia resource for brewers and beer lovers. Since 2005, we have been the leader in craft beer entertainment and information with live beer radio, podcasts, video, events and more.