cornelius keg lid clamp foot
Posted: Tue Mar 23, 2010 1:38 pm
by beltbuckle
Does anyone know of a Mcmaster-Carr part number that will work to replace the feet on the cornie keg lid clamps? Talking about this little guy:
Just seems like I should be able to get 10 for a dollar rather than a buck a piece...
Re: cornelius keg lid clamp foot
Posted: Tue Mar 23, 2010 5:46 pm
by Nyakavt
I just measured one of the post legs with some calipers. The diameter is 0.22" and the cap height is 0.65", at least on the 3 gallon keg I measured. So McMaster 6448K23 seems the closest match, although they say that one is 1" tall. 9753K12 may be a better fit, these are vinyl and only 1/2" tall inside.
Re: cornelius keg lid clamp foot
Posted: Tue Mar 23, 2010 7:04 pm
by beltbuckle
Thanks for the measurements. I think I'll buy a pack of the 1" ones as they look the closest. And I can just cut off the extra length.
Re: cornelius keg lid clamp foot
Posted: Sun May 02, 2010 4:54 pm
by Bob O
Did these caps work? I need a couple myself.
Re: cornelius keg lid clamp foot
Posted: Sun May 02, 2010 7:31 pm
by Grizz
Re: cornelius keg lid clamp foot
Posted: Mon May 03, 2010 1:01 pm
by Bugeater
If you are really cheap, just stick a penny under each of the legs of the clamp. That works out to $2.16 (plus shipping) less than the cost of a pair of the Keg Connection feet.
Just my two cents worth of information here.
Wayne
Re: cornelius keg lid clamp foot
Posted: Mon May 03, 2010 1:10 pm
by bcmaui
Bugeater wrote:If you are really cheap, just stick a penny under each of the legs of the clamp. That works out to $2.16 (plus shipping) less than the cost of a pair of the Keg Connection feet.
Just my two cents worth of information here.
Wayne
You have the McMaster code for the pennies Bug? I think they are available in bulk too, 50 or so in a package.
Re: cornelius keg lid clamp foot
Posted: Tue May 04, 2010 6:36 pm
by Weenie Boy
Bugeater wrote:If you are really cheap, just stick a penny under each of the legs of the clamp. That works out to $2.16 (plus shipping) less than the cost of a pair of the Keg Connection feet.
Just my two cents worth of information here.
Wayne
Probably the best two cents of advice I have heard in quite awhile.
Weenie Boy