Spacer???

[TimmyR]

Getting ready to drill my fridge door for faucets. Purchased shanks and equip from MoreBeer along with the 25mm hole saw. I've read some people like to use a length of PVC around the shank to protect the door. Do I need it? If so, I am looking at a larger hole saw of course, unless there is thinner walled PVC than Sched 40 out there someplace.

Thanks for the help!

[andy77]

Timmy, I've got nothing to say on your question, but looking at your "Waiting to Enjoy" list makes my mouth water. Those are some mighty fine looking, big ass beers.

[TimmyR]

Spacer, schmacer. Not needed. All drilled and fit. Just need to connect all the hoses, leak check and pressurize.

What are the pre-clean recommendations for the equip (new faucets, shanks, etc.). Was thinking I'd just run some PBW thru each connection, rinse, then Run StarSan thru.

[BigNastyBrew]

Was thinking I'd just run some PBW thru each connection, rinse, then Run StarSan thru.

That'll do 'er