Sankey keg in a Corney Kegerrator?

[fifthseason]

Currently running two corney kegs in a dual-tap keggerator, all ball-lock connections. Now I want to run a pair of Sankey kegs in the same setup, and was wondering what adapter(s) I might need to connect the Sankeys to the CO2 lines and beer lines. Could anyone point me in the right direction?

[Mylo]

This has come up before. PM Henning, or search for his posts. Basically it is a flare fitting that screws in where your ball locks go, and fits between the nut and the washer on the sanke rig. You need one for the gas and one for the beer for each one.


Mylo

[ApresSkiBrewer]

Here is one place to start...

http://northernbrewer.com/couplers.html

The lo-boy looks sick, and will prob be your best low profile fit in a smaller kegorator. Also it looks like w/ the right tubing/clamps you would only need to swap a few hoses.

No personal experience w/ this yet though, so let us know how it goes.

[Henning1966]

Try looking at this http://www.williamsbrewing.com/KEGERATO ... 1e$1D$EEp$

[Mylo]

Try looking at this http://www.williamsbrewing.com/KEGERATO ... 1e$1D$EEp$

That's what I was referring to. Thanks, Henning. I think the fittings are available themselves - assuming you have the rest of the stuff.


Mylo