Corny handles
Posted: Sat Jun 04, 2005 5:08 pm
Anyone got any tips for re-glueing the rubber handles to cornies? I tried gorilla glue and that didn't work.
Page 1 of 1
Posted: Sat Jun 04, 2005 6:23 pm
I think I remember someone using Liquid Nails with good results
Posted: Sun Jun 05, 2005 9:02 am
I'll give it a shot. Does anyone know if replacement rubber is out there?
Posted: Wed Jun 08, 2005 1:21 pm
I tried Gook and it was good for a while What about good ole crazy glue?
Posted: Fri Jun 10, 2005 3:12 am
I got one for ya, try 3M brand 5200 marine adhesive. That stuff WILL do the job weather it gets wet or not it'll hold. Don't get it on you or anything important though, it'll hair up and heal over before in wants to come off. Another truely excelent adhesive is PL brand polyurethane premium construction adhesive. Do be advised on this one there isn't a solvent for this product created yet, so if you get it on you DO wipe it off right away. Some clamping and cure time is required on both. Good luck.
Steve
Steve
Posted: Sat Jun 11, 2005 1:32 pm
Any good contact cement works well.Just be sure to clean the surfaces well and let it set up long enough before putting the parts together.
Posted: Tue Jun 14, 2005 9:09 pm
Where might I find that 3M 5200 stuff? Boat shops maybe?
Replacement o-rings
Posted: Sun Jun 19, 2005 6:32 am
