Hacker-Pshorr Ceramic Beer Tower

[pmanz]

Hi Everyone,
I'm new to this so please bear with me. I recently scored a brand new Hacker-Pschorr ceramic beer tower on eBay. It's just the top and bottom and I need to figure out where to get a 4-tap unit for in between the top and bottom ceramic pieces. I'd prefer to have all four taps on line like a regular bar vs. in an arc like most of the tap towers I've seen online. I figured if I got a nice nut for the hole in the top, I could run some thread bar down through and clamp the whole assembly to the underside of the counter top. [/img]

[Otterbrew]

You might want to hit up these guys:

http://www.tucher-usa.com/
(there is a link for beer paraphernalia)

These towers must be quite similar, and perhaps they can get the sub-assembly you need.

Good luck,
-Greg

P.S. Post a photo when you get it fully assembled and working

[Lufah]

Take a look here...

http://www.micromatic.com/

[pmanz]

Thanks for the feedback. I looked at the Micromatic guys but I wanted the taps all on line so they hang over the drip tray nicely. The Tucher looks like my best bet. I tried to post a pic to clarify but couldn't figure out how to do it... How do I post it... I am using Firefox on a Mac if that matters. I saw a button that says pic but it doesn't do anything for me...[/img][/code]

[Lufah]

Take a look here...

http://thebrewingnetwork.com/forum/viewtopic.php?t=943

If you still need help PM or email me.

Travis