Beer Forum

This is a forum for enlisted and new recruits of the BN Army. Home brewers bringing it strong! Learn how to brew beer, trade secrets, or talk trash about your friends.
http://thebrewingnetwork.com/forum/

Off flavors from High Fermentation temps??

http://thebrewingnetwork.com/forum/viewtopic.php?f=19&t=24735

Page 1 of 1

Off flavors from High Fermentation temps??

Posted: Tue Apr 05, 2011 8:31 pm
by Kbar
If fermenting in a 70F room, thus wort/beer at 70F+ (Exothermic process), can I expect some off flavors in the finished product? Esters?

12 batches All Grain in, and the beers I produce have a particular character to the aroma/taste

thanks!

Re: Off flavors from High Fermentation temps??

Posted: Tue Apr 05, 2011 8:43 pm
by ChrisKennedy
Yes, that would be problematically high temps for most beers.

Re: Off flavors from High Fermentation temps??

Posted: Tue Apr 05, 2011 8:44 pm
by MNHazmat
There's a good chance of it yes, depending on the yeast of course.

Re: Off flavors from High Fermentation temps??

Posted: Tue Apr 05, 2011 9:19 pm
by Kbar
90% of the time I am using 1056.........

Should have posted that. Thanks thus far!

Re: Off flavors from High Fermentation temps??

Posted: Thu Apr 07, 2011 9:27 am
by MNHazmat
Definitely too warm, considering that during active fermentation you can expect a 5+ degree rise. For 001/1056 I like to keep it (actual wort temp) at 65-67 during the active ferment, then raise to 70 for the clean up phase.

Re: Off flavors from High Fermentation temps??

Posted: Thu Apr 07, 2011 8:29 pm
by Bugeater
Definitely too warm. At the height of fermentation, depending on gravity, the temperature of the wort can be 5-10 degrees warmer than ambient temperature. Also, the warmer the ambient temperature, the higher the temperature rise. e.g. fermentation of a 1.050 b01eer at 65° might only rise 3-4° while at an ambient temperature of 70° might rise by 6-7°. If the gravity is higher the temperature rise will be even greater. If you are using a temperature controller, tape the temperature probe directly to your fermenter and cover with some sort of insulation (bubble wrap works great) to shield it from ambient temperature changes (usually from opening the door of your fermentation chamber). This will keep your wort at a steady temperature.

Wayne

All times are UTC - 8 hours
Page 1 of 1